What's New

Here are our newest products at BlueWater Manufacturing.

The Versa Clamp is the most versatile guardrail C-Clamp in the market place for Fall Protection. Use it on parapets as well as concrete slabs to provide the Fall Protection the workers deserve.
The StealthRail is a collapsible portable guard rail system. The most versatile guard rails in the industry and they exceed OSHA regulations. The StealthRail is a collapsible guard rail section for the SafetyRail 2000 Guardrail System. Its one-way pivot assembly allows the guardrail to fold on to a surface and then not exceeding a vertical plane when in the upright position. A detent pin on each pivot assembly locks the rails in the upright position.
The ParaRail (PATENT PENDING) was developed for total access to the parapet wall for maintenance/ installation on security cameras, lights or antennas. Each ParaRail is custom manufactured to the specific size parapet of the structure. Outriggers are mandatory when using the ParaRail even when used in a continuous run. Use it for permanent placement or use it as a portable fall protection system from one location to another.
The Grab Bar allows for easy egress and ingress of roof hatches and floor hatches. Install the Grab Bars as an option to the Fall Protection Hatch Kits and make it easier and safer for workers. The Grab Bar mounts to an open receiver on the SafetyRail 2000 base. Adjust the width of the bars to the width of the ladder inside the hatch or a little wider. Lock the Grab Bars into place with the securing pin and tighten the friction collar and your done. The Mount Pad is adjustable and enables the bars to be used when curbs are place in front of the hatch or on uneven surfaces. Note: Roof Hatch Kits will need longer side rails when using the Grab Bar. Contact the factory to size the Hatch Kit. Part # 500296 (includes 1 pair)
The Safety Strip provides a visual warning and protects against bumps almost anywhere. The bright safety yellow foam strips identify and cushion bump points on any condition that needs Safety/Caution signage with an additional need for cushioning. The SG2000 (PATENT PENDING) is BlueWater Mfg’s newest gate product. It is a sliding gate that can be used in place of our swing gates when there is not enough clearance to allow for a swing gate to open.	The “StepRail” enables a continuous run of SafetyRail 2000 when the roof “steps” up or down. The “Raised Mid-Rail” is used to fit over duct work and keep a continuous run of SafetyRail2000. Thus, reducing the need for outriggers at the interruption.
The BlueWater Self-Closing Safety Gate is tough, durable and best of all, economical, reliable, easy to install, and more closely matches the railings and their dimensional requirements provided for by Federal OSHA.	The LP Outrigger is used to continue a run of SafetyRail 2000 when ducting or conduit does not allow for a rail section to be used. The outrigger is placed under the object to continue the run, thus eliminating the needed outriggers when discontinuing the run. It also can be used as an outrigger when there is not enough available space for a standard rail outrigger. We do not recommend using the LP Outrigger as a standard outrigger. It creates a trip hazard and should only be used when all other options are exhausted.
The Finishing Rail is used to abut an access ladder. The 'D' Extension keeps the bases away from the ladder landing, thus eliminating a trip hazard at the egress/ingress point of the ladder that the bases may cause. Using two of these rails makes a great ladder access walkway that meets OSHA regulations. Adding a SafetyRail 2000 Gate creates a secured access area. We can manufacture to your needs. The most common size is 7ft long. This will bring the access point beyond the 6' OSHA set back from the leading edge.